china TC70 CONVEYOR BELT often touches a lot of raw materials during the whole process of operation. After a long time, the surface of china TC70 CONVEYOR BELT is very easy to leave some dirt that is not easy to remove. The accumulation of dirt over time is likely to stick some raw materials, which will harm the transportation rate of the china TC70 CONVEYOR BELT, and even cause the china TC70 CONVEYOR BELT to deviate. Therefore, china TC70 CONVEYOR BELT must be cleaned and maintained on time. The following is a detailed introduction to a very simple china TC70 CONVEYOR BELT cleaning method.

Before cleaning the china TC70 CONVEYOR BELT, all the machinery and equipment that cannot go out must be wrapped with plastic film to avoid water seepage and cause short-circuit failure of the motor, because the machinery and equipment cannot be used after being immersed in water.

The second step is to turn off the steam safety valve, check the tensioning equipment, and adjust the working pressure of the machinery and equipment.

The third step, check the status of the china TC70 CONVEYOR BELT cleaning equipment, and check the status of the china TC70 CONVEYOR BELT. If there are damaged parts on the conveying machinery, be sure to repair it in advance and then clean it up, otherwise it will endanger the application of the parts.

The fourth step, soak the china TC70 CONVEYOR BELT for a while before cleaning the china TC70 CONVEYOR BELT, it will be more convenient to clean up.

The fifth step, use the bottom pressure spray gun to evenly spray the cleaning solution that is evenly stirred. Never use a high pressure water jet as it will damage the surface of the china TC70 CONVEYOR BELT. When cleaning the spray gun, be careful not to repeatedly clean the same part, and ensure that every part of the drive belt can be cleaned.

Step 6. After the actual operation, clean the china TC70 CONVEYOR BELT with cold water, check the dirt on the transmission belt, and dry the transmission belt to prevent mold growth.