CC56 CONVEYOR BELT products are mainly used to transport goods, and they are widely used in factory assembly lines, logistics express, and airport transportation. Then, what are the reasons for the tearing and cracking of CC56 CONVEYOR BELT products after a period of use?

1. The reason for the tear of CC56 CONVEYOR BELT products.

Loosening and separation caused by long-term vibration and impact, falling of sidewalls and blocks, etc.; foreign matter is mixed in the product, the foreign matter is hard, and the edges and corners are relatively hard, which directly damages the conveyor belt; the idler of the conveyor is damaged, thus Resulting in scratches on the conveyor frame; CC56 CONVEYOR BELT products strayed and caught on the frame. Abrasion caused by the card owner; the product is scratched intentionally or unintentionally, causing the conveyor belt to be torn.

2. The reason for the disconnection of the CC56 CONVEYOR BELT products connector.

The diameter of the diverting roller is small, and the bending stress of CC56 CONVEYOR BELT products is large; the quality of the vulcanized joint of the conveyor belt is poor, especially if it has been vulcanized more than twice, the joint strength is obviously reduced, or the canvas layer is cut during gluing, or Grinding leaks, the strength is reduced here; for the conveyor that can be transported reversely, because the top and bottom overlap can only be in one direction, it is easy to be scratched by the sharp corners of some hard equipment on the belt; the conveyor has a short working cycle and starts and stops frequently , resulting in high tension.