TC70 CONVEYOR BELT are generally used to transport some relatively dirty materials, so usually after a long time of use, the dirt on the materials will not only affect the speed of transportation, but also sometimes cause the conveyor belt to deviate. After using the conveyor belt, it should be cleaned in time to keep the belt surface clean. So how to clean the TC70 CONVEYOR BELT? Let the professional belt manufacturers give you the corresponding explanation.

1. Before cleaning, wrap all electrical equipment that is afraid of water with plastic film to prevent water from causing short circuit of the motor.

2. Close the steam valve and observe the condition of the tensioning device to adjust the pressure of the equipment.

3. Check the working state of the cleaning machine and check whether the conveyor belt is in good condition. The damaged parts must be repaired in advance before cleaning.

4. In order to better clean the conveyor belt, the belt should be soaked before cleaning.

5. Spray the evenly stirred cleaning solution with a low-pressure spray gun. Be careful not to use a high-pressure spray gun, because this will damage the surface of the belt. When washing the spray gun, be careful not to repeatedly wash the same position.

6. Finally, rinse with clean water. Check for stains on the TC70 CONVEYOR BELT and clean it and then dry the belt to prevent mildew.