How to do the anti-skid treatment of the cc56 conveyor belt? Under normal circumstances, we will choose the patterned conveyor belt on it, which is what we call the patterned conveyor belt. The patterns on the top are of various styles and heights. Problems, such as falling during transportation, etc., in addition to choosing patterned rubber belts, you can also choose large-angle conveyor belts, which are equipped with baffles and partitions.

                                                    cc56 conveyor belt

                                                                            cc56 conveyor belt

When the conveyor belt is used, if it is a patterned conveyor belt, the anti-skid effect is ok, and the principle is also simple. It is to increase the surface roughness and increase the friction force, which can effectively avoid the occurrence of slippage. There were no various rubbers in the past. Belts, which follow the development needs of the times, gradually appeared, and there are many types of patterns on them, including horizontal, granular, block, powder and other types of molds. The application is used in many places, and there are many materials to be transported, and the angles of transportation are not parallel. If a large inclination conveyor belt is used, it can transport 0-90°.

In addition to the non-slip treatment of the selected products, there is another factor that cannot be ignored, that is, the slippage between the conveyor belt and the pulley occurs during use. There are three solutions:

1. Tighten the upper and lower conveyor belts;

2. Check whether the adjustment mechanism of the belt tightening device needs to be tightened;

3. Replace or roughen the existing anti-skid surface.

At the same time, if the conveyor belt slips, the above is no problem, then check whether the pattern of the CC56 CONVEYOR BELT is not high enough, or whether it is damaged. Comprehensive analysis. It is time to replace the conveyor belt with a new one.