During the operation of CFW CONVEYOR BELT, the tape will stretch, resulting in a decrease in the driving force. Therefore, according to the situation, use the tensioning device to properly tighten the tape and increase the tension of the tape to increase the driving force. Expand frictional resistance. The specific method is: protect the wooden lining or plastic gaskets covered on the drive roller to increase the frictional resistance, on the other hand, reduce the amount of water and coal to prevent the frictional resistance from decreasing.

Because CFW CONVEYOR BELT works poorly and requires a large driving force, it often uses a double-drum transmission system to expand the wrapping angle. Sometimes the conveyor belt will deviate due to the defects caused by the manufacture, installation and use of the conveyor. When the deviation is too much, the conveyor belt will contact the idler bracket and the frame, causing the edge rubber to wear and even the conveyor belt to flang .

The wear of the baffle to the CFW CONVEYOR BELT is a special kind of wear, such as improving the design method of the baffle and paying attention to maintenance, this kind of wear can almost be prevented. The lower cover rubber of the conveyor belt is also subject to the friction of the self-aligning roller and the forward-inclining trough roller, and wear occurs at the transition section from the trough roller to the drum and at the curved protrusion of the conveyor. If slipping or pulling does not occur during use, the fault should be detected in time, and the tensioning system should be adjusted to keep the tensioning device flexible.