1. Restoring the edge size process: For the damaged edge with a larger size, the method of restoring the edge size is used to repair it. The purpose is to restore the usable area of ​​the TC70 CONVEYOR BELT and prevent the further expansion of the edge damage of the conveyor belt. Construction points:

Firmly bond the L-shaped polyurethane repair strip with a thickness of 18 mm and a width of 10 mm, or a square polyurethane repair strip with a thickness of 15 mm and a width of 30 mm on both sides and the lower side of the TC70 CONVEYOR BELT edge. The conveyor belt repair glue fills the irregular conveyor belt edge and makes it a strong flexible whole. The advantages of the scheme are: one is to convert the edge of the upper, middle and lower three-layer structure into the edge of thickness, and the other is to convert the rubber edge with low wear resistance and impact resistance into a polyurethane edge with excellent wear resistance and impact resistance. .

2. The process of wrapping the edge: if the damage to the edge is small in size, the method of wrapping the edge is used to repair it. The purpose is to prevent the edge breakage from expanding further. Construction points introduction:

Wrap a 2.5mm thick, 10mm wide strip of polyurethane patch around the damaged edge. Its advantages are: make the upper and lower rubber and core rubber form a complete whole at the edge, obtain a tough protective layer, resist edge impact and damage; improve the wear condition of the lower side, and stick a stick on the weak part of the edge of the conveyor belt. Layer of wear-resistant material to achieve the purpose of protecting the TC70 CONVEYOR BELT.