Under normal conditions, insufficient parallelism of the lower MULTI-PLY CONVEYOR BELT and insufficient height of the drag rollers will cause the underside of the conveyor belt to shift. Bottom side closed, top side normal. This situation is basically caused by poor thorough cleaning setup, lower rollers getting stuck with material, unfair counterweight idlers or tilting of the counterweight support and the lower rollers against each other. Due to the unfairness of the practice, the specific situation should be adjusted according to the actual situation.

In general, the deviation on the lower side can be corrected. This problem can be rectified by improving the office state of the entire cleaning unit, removing material from the drag rollers and rollers, debugging the lower flat rollers, the lower V-shaped drag rollers, or installing the lower side self-aligning rollers. correct.

The deviation adjustment drag roller is an automatic centering roller installed on the MULTI-PLY CONVEYOR BELT, which can automatically correct the deviation of the tape. As the tape deflects and rubs against the aligned small detent rollers, the side brackets will move forward in the direction the tape is running and the tape will move to the other side until it returns to its normal position.

It should be noted that when adjusting the deviation of the MULTI-PLY CONVEYOR BELT, do not rush to success. Adjust slowly and watch carefully during fine-tuning until you are satisfied.