Since the quality CC56 CONVEYOR BELT will be affected by various factors during the running process, the deviation will occur. In order to ensure the service life of the interface, the interface will not be torn when the quality CC56 CONVEYOR BELT is deviated, and can be adjusted according to the operation of the belt. Orientation, make the mouth a /convex 0 shape.

The key to the production of the steps at the interface is the cutting. After counting, measuring, and marking, the excess rubber and cloth layers can be removed. During operation, the force of the lower knife and the depth of the stroke must be strictly controlled. If the undercut is too deep, the remaining part of the cloth layer will be damaged, resulting in local breakage in the future; otherwise, it will be difficult to remove the excess rubber and cloth layer.

Therefore, this is the key technology of the bonding process, which must be performed by experienced personnel or directed on the spot. After the grinding steps of the joint surface are torn off, the initial joint is carried out, and the non-matching parts are corrected, and then the joint surface grinding work should be carried out. The purpose of grinding is to knock off the rubber adhering to the cloth layer, and at the same time grind the cloth layer, in order to receive the effect of increasing the roughness of the cloth layer, increasing the bonding area and improving the bonding strength. Practice has confirmed that, under certain conditions, the bonding strength will increase correspondingly with the increase of roughness.

The bonding operation of quality CC56 CONVEYOR BELT is difficult and technical. It is necessary to select the appropriate interface shape according to different working conditions, reasonably determine the lap length, and use high-performance and high-strength adhesives. Through scientific and meticulous operation, to get the desired effect.