TC70 CONVEYOR BELT products There are usually three joint methods, namely mechanical joints, cold glue joints and hot vulcanized joints. The strength of the TC70 CONVEYOR BELT products joint is lower than the strength of the belt itself. When TC70 CONVEYOR BELT products use mechanical joints, the joint strength can only reach 40-50% of the strength of the belt body; when TC70 CONVEYOR BELT products use cold glue bonding, the joint strength The strength can reach 60-70%; assuming that the hot vulcanized joint is selected, the joint strength of TC70 CONVEYOR BELT products can reach 80-90% (the joint method is accurate and there is no quality defect).

The strength of the joint part of TC70 CONVEYOR BELT products is relatively low. If the bonding method is not accurate, the strength of the joint of TC70 CONVEYOR BELT products will be lower; if the knife is opened, the TC70 CONVEYOR BELT products will damage the next layer of canvas when grinding, excessive grinding, and overlapping. The length is not enough, the number of steps is not enough, the rubber function of the joint is not good or the self-sulfurization has failed, the wire rope is too polished, the wire rope is rusted, etc., the strength of the joint part will be greatly reduced, and it is relatively easy to appear TC70 CONVEYOR BELT products The phenomenon that the joint is disconnected and cracked. TC70 CONVEYOR BELT products If the sealing glue is not used, or the direction of the joint is wrong, the joint (surface glue part) of TC70 CONVEYOR BELT products will also crack.