1. How to connect two China CFW CONVEYOR BELTs with different layers: In general, two China CFW CONVEYOR BELTs with different thicknesses, including different cloth models, cannot be connected.

2. Bonding method of China CFW CONVEYOR BELT: It is recommended that China CFW CONVEYOR BELT be bonded by heat vulcanization (professionals), and core glue is required in the middle. Each step can only have one layer of cloth, and the direction of the joint should follow China In the direction of CFW CONVEYOR BELT running, although the cold bonding efficiency is fast, the effect is slightly poor.

3. Why China CFW CONVEYOR BELT joints are easy to crack and break: the strength of China CFW CONVEYOR BELT joints cannot be reached, which is generally caused by the tension of the cloth layer or insufficient bonding. china CFW CONVEYOR BELT is widely used in cement, coking, metallurgy, chemical industry, steel and other industries where the conveying distance is short and the conveying volume is small. Generally, when connected by mechanical means, the joint strength can only reach 40-50% of the belt body strength. 80-90% (joint method is correct, no quality defects). Because the strength of the joint is relatively low, if the bonding method is incorrect, the strength of the joint will be even lower, such as cutting, damaging the next layer of cloth during grinding, excessive grinding, insufficient lap length, insufficient number of steps, bonding The rubber used in the joints has poor performance or has expired due to self-sulfurization, the steel wire rope has been excessively polished, and the steel wire rope has rusted, etc., the strength of the joint will be greatly reduced, and the joint is prone to disconnection during use. In addition, if the china CFW CONVEYOR BELT does not use sealing glue, or if the direction of the glue joint is wrong, the joint part is prone to cracking (surface glue part).