1. Grind the damaged part of China CC56 CONVEYOR BELT with an angle grinder and a tungsten steel grinding disc.

2. According to the size of the damaged part of China CC56 CONVEYOR BELT, select the corresponding China CC56 CONVEYOR BELT repair sheet or repair strip with semi-vulcanized layer (the repair strip or repair sheet is at least 15~20mm larger than the damaged part). It is recommended to use semi-vulcanized layer for repair For strips, repair pieces, and materials without semi-vulcanized layers, it is recommended to perform deep grinding on the bonding surface.

3. Apply belt adhesive to the damaged part of China CC56 CONVEYOR BELT and the semi-vulcanized surface of China CC56 CONVEYOR BELT repair strip, let it dry for a while, and then apply the second coat (until it is not sticky to the hands, generally under normal temperature in five minutes).

4. Straighten the repair strip and attach it to the polished surface of China CC56 CONVEYOR BELT, and use a rubber hammer or a compacting roller to tap and compact it to drive out the air.

Reminder: If the ambient temperature is too low, it is recommended to use an iodine tungsten lamp or a heat gun to heat for 0.5-1 hour. If the time is allowed to extend the heating time appropriately, it will help to improve the strength of the bonding surface.