When choosing a motor for the TC70 CONVEYOR BELT, you need to be careful, choose according to the power required by the production machinery, and try to ensure that the motor operates under the rated load. If the power of the motor is small, there will be a situation of a small horse-drawn cart, which will cause the motor to run overloaded, which will easily cause heat and damage the motor. On the contrary, if the power of the motor is too large, it is a big horse-drawn trolley, causing waste of electric energy. In addition, the environment where the motor is installed should be careful to avoid oil pollution and moisture, so as to avoid fire or damage to the machine.

Vulcanization treatment process of TC70 CONVEYOR BELT: The curing time is twice that of ordinary conveyor belts. Insufficient curing time or low temperature will easily cause foaming of the rubber layer. Therefore, it is necessary to strictly follow the process regulations in production to ensure product quality.

Processing of the TC70 CONVEYOR BELT: There are several aspects that need to be paid attention to: avoid the idler being covered by the material, prevent the leakage of the material from being stuck between the roller and the belt, pay attention to the lubrication of the moving parts of the conveyor belt; prevent the conveyor belt from overloading; the conveyor belt runs If there is any deviation, corresponding measures should be taken in time; when local damage to the conveyor belt is found, use artificial cotton to repair it in time to avoid expansion; avoid the conveyor belt being blocked by the frame, pillars or block materials to prevent it from being broken and torn.