The tc70 conveyor belt  is slipping. The reason may be that the tension of the tc70 conveyor belt  of the belt conveyor is small or the surface of the driving roller is stuck with material or moisture. Here, it is recommended that you turn the tensioning screw to increase the tension. Clean the drive rollers and increase the cleaning power of the empty section cleaner.

The tc70 conveyor belt  is misaligned at both ends. The reason may be that the assembly position of the drum is skewed, and the screw of the tensioning device on the side of the deviation should be tightened to adjust the position of the drum. Adjust the position of the drive drum by adjusting the bearing seat.

The tc70 conveyor belt  is misaligned in the middle. The reason may be that the rollers are not installed in the correct position. It should be checked whether the installation position of each idler is perpendicular to the conveyor belt of the belt conveyor, otherwise loosen the installation bolts to adjust the idler position. After adjustment, tighten all bolts.

In addition, the blanking point of the feeding port is not in the center of the tc70 conveyor belt , which may also cause deviation, and the feeding situation should be improved.